Comtech EF Data MBT-4000 Installation And Operation Manual page 67

Multi-Band Transceiver System
Remote Command
Command
Valid on
Parameter (Instruction
MBT,
Type Code and
BDC, or
qualifier)
BUC
Redundancy RED=x MBT
State
Reference REF=xxxx MBT
Oscillator Adjust
Retrieve N/A
Equipment Type
Arguments for
Command or (Note that all arguments are ASCII numeric codes, that is,
Response to
Query
1 byte, Command or Query.
value of 0,1, or Controls redundancy state.
2 0=Off
1=Enables redundancy using single base unit
2=Enables redundancy using dual base units
Example: RED=1
4 bytes, Command or Query.
numeric Ref Osc Adjust, between 0000 and 0255.
Resolution 0001.
Example: REF=0197
Note: REF cannot be adjusted when the unit is locked to an
external reference source.
All 22 bytes, Query only.
alphanumeric The unit returns a string indicated the Model Number and the
software version installed
Example: RET=BUC-4000 VER:1.0.3
MN/MBT4000.IOM
Description of arguments
ASCII codes
between 48 and 57)
A-23
Revision 3
Query
Response to
(Instruction
Command
Code and
(target to controller)
qualifier)
RED= (message ok) RED?
RED? (received ok, but
invalid arguments
found)
RED* (message ok, but
not permitted in current
mode)
REF= (message ok) REF?
REF? (received ok, but
invalid arguments
found)
REF* (message ok, but
not permitted in current
mode)
N/A RET?
Response to
query
(target to
controller)
RED=x
(same format
as command
arguments)
REF=xxxx
(same format
as command
arguments)
RET=x....x
(see
description for
details of
arguments)