Changing The Drive Wheel; Removal; Fitting - Permobil Chairman Basic Service Manual

Changing the drive wheel

Changing the drive wheel

Removal

1. Raise and block up the wheelchair's chassis
so that the wheel does not reach the
ground.
2. Loosen and remove the centre screw C, the
washer B and the rim locking washer A (see
the figure at the bottom of the page).
3. Pull the wheel off the axle. Use the removal
tool 304103-99-0 if the wheel cannot be
removed by hand.

Fitting

1. Fit the wheel onto the axle.
2. Fit the rim locking washer A, the washer B
and the centre screw C and tighten to
secure the wheel.
NB! The screw has a locking coating which is
sufficient for refitting 3-4 times. Then the screw
must be replaced with a new one.
Removal tool 304103-99-0
10