Central Machinery 46813 Assembly And Operating Instructions Manual page 5

7. Keep all guards in place and in wOrKing Order.
reMOVe all adJusting wrenches FrOM the table saw beFOre
8.
turning it On.
aVOid unintentiOnal starting. Make sure you are prepared to begin
9.
work before turning the Power Switch (part #8E) "ON".
dO nOt use this tOOl FOr cutting Metals Or brittle Materials.
10.
Do not cut dangerous materials, such as asbestos that can cause harmful dust or
vapors.
allOw the saw blade (part #14-I) tO spin up tO Full speed beFOre
11.
Feeding wOOd intO it. When turning it off, allow the Saw Blade to spin down
and stop on its own. Do not press against the Saw Blade to stop it.
caution: Never pass hands directly over the Saw Blade (part #14-I) when
12.
cutting the workpiece. Always push the workpiece into the Saw Blade, using an
auxiliary handle or push stick (not provided).
dO nOt FOrce the Material intO the saw blade (part #14-i) when
13.
cutting. Apply moderate pressure, allowing the Saw Blade to cut without be-
ing forced.
14. neVer atteMpt tO reMOVe Material stucK in the MOVing parts
OF the table saw while it is plugged in and running.
15. turn OFF the table saw iF the wOOdstOcK is tO be bacKed Out
OF an uncOMpleted cut.
always Keep hands and Fingers away FrOM the saw blade (part
16.
#14-i). Use an auxiliary handle or push stick (not provided) at all times.
MaKe sure the wOrKpiece is Free FrOM nails and any Other
17.
FOreign ObJects which cOuld daMage the saw blade (part #14-i).
always Feed the wOrKpiece intO the saw blade (part #14-i) and
18.
against its rOtatiOn.
warning: When replacing the Saw Blade (part #14-I), ALWAYS replace it with
19.
a Saw Blade rated at least 3,400 rpM to prevent possible injury.
reduce the risK OF KicKbacK. Kickback is caused when the Saw Blade
20.
(part #14-I) becomes pinched, miss-aligned, or twisted during the cutting
process, resulting in personal injury and/or damage to the tool.
SKU 46813 PAGE 5