Central Machinery 46813 Assembly And Operating Instructions Manual page 13

nOte: The back side of the Front Rail (part #7H) has two slots. Slide the upper
3.
slot of the Front Rail over the Square Head Bolts (part #10H). (see Figures F, g,
and assy. diagram h.)
HEX NUT (#13H)
WASHER (#12H)
SEMI-CIRCLE
HEAD SCREW
(#2E)
4. To align the Front Rail (part #7H), match the 7-1/8" mark on the right scale with
the right edge of the 10" Table Saw Base (part #1G). (see Figure h, and assy.
diagram h.)
5. Wrench tighten all five Square Head Bolts (part #10H).
(see Figures F, g, and assy. diagrams g, and h.)
6. Secure the Right/Front End Cap (part #8H) and Left/Front End Cap (part #9H) to
the Front Rail (part #7H), using one Tapping Screw (part #1H) on each end.
(see assy. diagram h.)
To Attach The Rear Rail:
1. nOte: The procedure for attaching the Rear Rail (part #3H) to the 10" Table Saw
is similar to that of attaching the Front Rail (part#7H) to the Table Saw. (see "To
Attach The Front Rail" section, Figures i, J, and assy. diagram h.)
2. Insert five Square Head Bolts (part #10H) through the mounting holes in the
rear edges of the 10" Table Saw and Extension Tables (part #5H). Allow the bolt
heads to extend out about 1/2". (see Figures i, J, and assy. diagram h.)
SKU 46813
(FRONT EDGE)
10" TABLE SAW/EXTENSION
TABLES (#5H)
SWITCH PLATE
(#3E)
SQUARE
NUT(#4E)
SQUARE HEAD BOLT (#10H)
(LOWER SLOT)
PAGE 13
(UPPER SLOT)
FRONT RAIL (#7H)
Figure g