Table of Contents
Advertisement
Volume display
You can display the volume either as a number or in dBs. In Numeric mode, the
volume is shown from 0 to 60. In Decibel mode, the volume is shown from -60 to
0dB. Choose the type of display you prefer using the LEFT or RIGHT buttons. Press
OK to confirm your selection.
Max. volume
Max. Volume lets you limit the maximum listening volume anywhere between
0dB (max. volume) and -20dB (party setting/child-proofing). Set the maximum
volume in 0.5dB steps using the UP or DOWN button. Press OK to confirm your
selection. Even after you have limited the volume in this way, you will still be able
to adjust the volume by 60dB – the adjustment range is simply shelved
downwards.
Mute level
Set the mute level in 0.5dB steps using the UP or DOWN button. Press OK to
confirm your selection.
Absolute phase
Certain recordings sound better when you reverse the polarity of the audio
signal, although the difference is minimal with most recordings.
Set the phase of the analog output signal to 0° or 180° using the LEFT or RIGHT
button. Press OK to confirm your selection.
Display brightness
When you start using the 830, its display is set to maximum brightness. After
about 15 seconds, the display changes to the brightness setting you have
specified in the display brightness menu. To avoid wearing out the display
prematurely, do not set the display brightness too high.
You can choose three brightness levels (75%, 50% or 25%) using the LEFT or
RIGHT buttons. Press OK to confirm your selection.
Reset to default (factory settings)
Use this option to restore the configuration menu to the standard settings. To
carry out a reset, choose Yes following the warning message, and confirm with
the OK button.
830 Stereo Control Amplifier
17
Advertisement
Table of Contents
