Using The 830 For The First Time - Lindemann 830 Owner's Manual

Using the 830 for the first time

•
Turn the power switch (on the rear panel) to its off position.
•
Connect the control amplifier to a wall outlet using a high quality power cord
if possible. The cable supplied is for test purposes only.
recommend that you use a high quality power cable. Make sure that the
voltage shown on the model identification plate matches the voltage of your
mains supply. If you intend to swap interconnects at any time in the future,
always remember to switch the control amplifier off first. Failure to do so
could damage the unit.
•
For safety reasons, the remote control is supplied without the batteries
installed. Please insert the batteries supplied, observing the polarity marks
shown on the battery compartment.
•
We have provided controls on the front panel to allow you to access the
important control functions of the 830. The remote control allows you to
access these and all the other functions of the unit.
•
Switch on the unit using the power switch on the rear panel. Your control
amplifier is now in standby mode and ready for use. This is indicated by the
blue Standby LED.
830 Stereo Control Amplifier
12
We strongly