Table of Contents
Advertisement
Phase
Phase
You can swap the absolute phase setting (0° or 180°) of each
You can swap the absolute phase setting (0° or 180°) of each
input to compensate for the phase characteristics of individual
input to compensate for the phase characteristics of individual
sources and to avoid having to resolder balanced interconnect
sources and to avoid having to resolder balanced interconnect
cables to account for different pin allocations.
cables to account for different pin allocations.
Fix to 0dB (bypass)
Fix to 0dB (bypass)
The Fix to 0dB feature simplifies the integration of the 830 within a home cinema
The Fix to 0dB feature simplifies the integration of the 830 within a home cinema
system. It allows you to switch each input individually to a 0dB mode in which
system. It allows you to switch each input individually to a 0dB mode in which
the signal is passed from input to output without either gain or attenuation.
the signal is passed from input to output without either gain or attenuation.
When you assign Fix to 0dB to an input, it passes through the preamp without
When you assign Fix to 0dB to an input, it passes through the preamp without
any change in level. When you switch to another input, the preamplifier will use
any change in level. When you switch to another input, the preamplifier will use
the last gain setting you used.
the last gain setting you used.
This feature is useful if you wish to use the stereo channels from a surround
This feature is useful if you wish to use the stereo channels from a surround
sound decoder as the front channels. The gain is then controlled by the decoder.
sound decoder as the front channels. The gain is then controlled by the decoder.
Link Mode
Link Mode
The 830 is able to communicate with other compatible Lindemann components
The 830 is able to communicate with other compatible Lindemann components
via SYSCOM. This Link Mode allows a single remote control to be used for all
via SYSCOM. This Link Mode allows a single remote control to be used for all
Lindemann components.
Lindemann components.
To use this feature, all components must be linked with a SYSCOM cable (see
To use this feature, all components must be linked with a SYSCOM cable (see
diagram below). You must switch off all components before changing any
diagram below). You must switch off all components before changing any
SYSCOM connections, as a re-start is required to ensure that the system
SYSCOM connections, as a re-start is required to ensure that the system
recognizes all of the components.
recognizes all of the components.
Important: You can only control the 820/822 CD player and 830 preamplifier
Important: You can only control the 820/822 CD player and 830 preamplifier
with the same remote control when Link Mode is active; otherwise, both
with the same remote control when Link Mode is active; otherwise, both
components could react simultaneously to commands such as volume, etc. The
components could react simultaneously to commands such as volume, etc. The
two components should be positioned directly adjacent to or above and below
two components should be positioned directly adjacent to or above and below
each other to ensure that both remote sensors receive commands from the
each other to ensure that both remote sensors receive commands from the
system remote at the same time.
system remote at the same time.
The possible SYSCOM connections are:
The possible SYSCOM connections are:
Master
830
Pre Amp
19
19
830 Stereo Control Amplifier
Slave
820/822
CD/SACD
850
Power Amp
850
optional
Advertisement
Table of Contents
