VIETA VDC-48 User Manual page 19

NAM:
A descriptive name of up to 12 characters can be assigned to each
program.
7.4 Device Configuration
MODE:
The unit assigns the Input source for the corresponding outputs when the
Mode of Operation is changed. The crossover point parameters like the
filter type, cut-off frequency and slope have to be configured manually in
the Crossover Menu for each Output Channel.
Mode: Out 1
None Any
Stereo 2-Way
Stereo 3-Way
Stereo 4-Way
*Note: The configuration mode configures the input sources when selected.
The user can change the source afterwards if desired. It does not keep the
configuration in memory.
7.5 Copy Channels
Copy Channels from the source to the target. When the Source and
Targets are both Inputs and Outputs, all audio parameters will be copied.
When one of the Source or the Target is an input while the other is an
output, only the Level, Polarity, Delay, EQ, Crossover, and Channel Name
are copied.
SYSTEM
NAM:
SYSTEM
MODE:None
Out 2 Out 3
Any Any
In1 In1 In2
In1 In1 In1
In1 In1 In1
VIETA VDC-48 User Manual - Page 19
Store
Config
Out 4 Out 5 Out 6
Any Any
In2 Any
In2 In2
In1 In2
Out 7 Out 8
Any Any Any
Any Any Any
In2 Any Any
In2 In2 In2