Appendix; ❶ Troubleshooting; Indicator Messages - Dukane 6233 User Manual

8. Appendix

❶ Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator
Indicator Condition
Off
Blinking light Blue 0.5 sec On,
0.5 sec Off
2.5 sec On,
0.5 sec Off
Orange 0.5 sec On,
0.5 sec Off
Steady light Blue
Orange
Red
Status Indicator
Indicator Condition
Off
Blinking light Red 1 cycle (0.5 sec
On, 2.5 sec Off)
2 cycle (0.5 sec
On, 0.5 sec Off)
3 cycle (0.5 sec
On, 0.5 sec Off)
4 cycle (0.5 sec
On, 0.5 sec Off)
6 cycle (0.5 sec
On, 0.5 sec Off)
Orange 1 cycle (0.5 sec
On, 2.5 sec Off)
Green
Steady light Green
Orange
Lamp Indicator
Indicator Condition
Off
Blinking light Red
Steady light Red
Green
* For more information on "sleep mode", see page 123.
Over-Temperature Protection
If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp
with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
• Unplug the power cord after the cooling fans stop.
• Move the projector to a cooler location if the room where you are presenting is particularly too warm.
• Clean the vents if they are clogged with dust.
• Wait about 60 minutes until the inside of the projector becomes cool enough.
Projector Condition
The main power is off
The projector is getting ready to turn on.
Off Timer is enabled.
The projector is cooling down.
The projector is turned on.
The projector is [NETWORK STANDBY] mode or
sleep mode*.
[NORMAL] is selected for [STANDBY MODE]
Projector Condition
Power on or Standby ([NORMAL] or [NETWORK
STANDBY] for [STANDBY MODE])
Lamp cover error or lamp housing error
Temperature error
Power error
Fan error
Lamp error
Network conflict
Re-firing the lamp (The projector is cooling down.) The projector is re-firing.
The projector is in [NORMAL] mode or sleep mode. –
CONTROL PANEL LOCK is on.
CONTROL ID error
Projector Condition
Normal
Lamp has reached its end of life. Lamp replacement
message will be displayed.
Lamp has been used beyond its limit. The projector
will not turn on until the lamp is replaced.
[ECO MODE] is set to [AUTO ECO], [NORMAL] or
[ECO]
135
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
–
Note
–
Replace the lamp cover or lamp housing correctly.
The projector is overheated. Move the projector to a
cooler location.
Power unit is not working properly. Contact your
dealer.
Fans will not work correctly.
Lamp fails to light. Wait a full minute and then turn
on again.
Both the built-in wired LAN and the wireless LAN cannot be
connected to the same network at the same time.
To use both built-in wired LAN and wireless LAN at the same
time, connect them to different networks. When the projector
is in NORMAL STANDBY mode or NETWORK STANDBY mode,
even if a network conflict occurs, the STATUS indicator will
not blink orange.
Wait for a moment.
You have pressed cabinet button when Control Panel
Lock is on.
Remote control ID and projector ID are not matched.
Note
–
Replace the lamp.
Replace the lamp.
–