Appendix; ❶ Troubleshooting; Indicator Messages - Dukane 6650HDA User Manual

9. Appendix

❶ Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

POWER Indicator
Indicator Condition
Off
Blinking Blue 0�5 sec On,
light 0�5 sec Off
2�5 sec On,
0�5 sec Off
Orange (short flashes)
Orange (long flashes)
Steady Blue
light
Orange
Red
STATUS Indicator
Indicator Condition
Off
Blinking Red 1 cycle (0�5 sec
light On, 2�5 sec Off)
2 cycle (0�5 sec
On, 0�5 sec Off)
3 cycle (0�5 sec
On, 0�5 sec Off)
4 cycle (0�5 sec
On, 0�5 sec Off)
6 cycle (0�5 sec
On, 0�5 sec Off)
Orange 1 cycle (0�5 sec
On, 2�5 sec Off)
Green 0�5 sec On,
0�5 sec Off
Steady Green
light
Orange
* The sleep mode refers to the mode in which the restrictions to functions due to the [STANDBY MODE] settings have been elimi-
nated.
LAMP Indicator
Indicator Condition
Off
Blinking Red
light
Steady Red
light
Green
Projector Condition
The main power is off
The projector is getting ready to turn on�
Off Timer is activated�
Program timer (off time) is activated�
Cooling
On Timer is activated�
Program timer (on time) is activated�
The projector is turned on�
Sleep mode*
In Standby condition [NETWORK STAND-
BY] is selected for [STANDBY MODE]
In Standby condition [NORMAL] is
selected for [STANDBY MODE]
Projector Condition
Normal or Standby
Cover error
Temperature error
Power error
Fan error
Lamp error
Network conflict
Re-firing the lamp (The projector is cool-
ing down)
Sleep mode*
CONTROL PANEL LOCK is on�
CONTROL ID error
Projector Condition
Normal
Lamp has reached its end of life� Lamp
replacement message will be displayed�
Lamp has been used beyond its limit� The
projector will not turn on until the lamp is
replaced�
[ECO MODE] is set to [AUTO ECO], [NOR-
MAL] or [ECO]
Without connecting the power cable�
Wait for a moment
–
Wait for a moment
–
–
While the STATUS Indicator lights in Green
–
–
–
The lamp cover is not set properly� Reset the lamp
cover� (→ page 122)
The projector is overheated� Move the projector to a
cooler location�
Power unit is not working properly� Contact your dealer�
Fans will not work correctly�
The lamp is not turned on� Wait over 1 minute and
power on the projector again� Even though the lamp is
not turned on, ask your dealer or service personnel for
repair�
Both the built-in wired LAN and the wireless LAN cannot
be connected to the same network at the same time�
To use both built-in wired LAN and wireless LAN at the
same time, connect them to different networks�
NOTE: In the Standby condition, the status indicator
on the cabinet does not blink in orange even if the
network conflicts
Wait for a moment
While the POWER Indicator lights in Orange
You have pressed cabinet button when Control Panel
Lock is on�
Remote control ID and projector ID are not matched�
–
Replace the lamp�
Replace the lamp�
–
125
Note
Note
Note