WARNINGS
The YX230 complies with FCC/IC regulations. Follow all guidelines and read this
information completely before beginning the installation procedure. Never
operate the system in an unintended application.
All cellular phones in the vicinity of the Amplifier should be turned off during
installation. Only after unit is installed should cellular phones be turned on and
tested with the system.
Make sure to connect to a 12V source that loses power when vehicle is off, or
make sure 12V DC CL Adapter switch is off. Battery will drain otherwise.
Only the provided power cable is to be used with the Wi‐Ex systems. Using any
other power cable will harm the system. The Wi‐Ex's warranty will be voided if any
other power cable is used.
Only the antennas provided with the Wi‐Ex system may be used. Use of any other
antenna could adversely impact the performance of the system, cause damage to
the unit and would void the warranty.
Changes or modifications not expressly approved by Wi‐Ex will void the user's
authority to operate the equipment.
Installation Instructions
We recommend that individuals not accustomed to the installation of mobile
electronics seek the services of a professional installer.
Step 1. Position Amplifier Unit ‐ Position Amplifier Unit within interior of vehicle
and within a 3‐4 ft. reach of a 12V DC Port. Choose a location where it rests flat and
is not a hazard to driver (i.e. under seat).
Step 2. Position Exterior Magnetic Mount Antenna ‐ Position Exterior Magnetic
Mount Antenna on top of vehicle, making sure magnet is secured to metal surface.
Then route cable from Exterior Magnetic Mount Antenna and connect to Amplifier
Unit.
NOTE: Cord will run from exterior to interior of vehicle. Cord is designed to
withstand pressure when closed in a door.
Step 3. Position Interior Patch Antenna ‐ Position the Interior Antenna with the fewest
obstructions between the antenna and the normal operating position of the cell
phone. When the Antenna is in the desired position, it should be no less than 8 inches
(20cm) from the normal operating position of the cell phone. Next, route the Antenna
cable and connect to the Amplifier Unit. Avoid placing the Antenna behind any metallic
objects (ie. mirror in sun visor). Do not attach to any metal surface.
IMPORTANT: For optimal performance, do not affix Interior Antenna to windshield.
6