Electrical Specifications - zBoost YX230 User Manual

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and the operator's body. This transmitter must not be co‐located or operating
in conjunction with any other antenna or transmitter.
IC: 5544A‐YX230
The manufacturer's rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB,
especially where the output signal is re‐radiated and can cause interference to adjacent band users.
This power reduction is to be introduced by means of lowering input power or gain reduction and
not by an attenuator at the output of the device.
WARNING: Changes or modifications not expressly approved by Wi‐Ex could void the user's
authority to operate the equipment.
3. Electronic Specifications
 Frequency:
TX: 824‐849 MHz/1850‐1910 MHz
RX: 869‐894 MHz/1930‐1990 MHz
 Gain: Up to 42 dB (Dual Band, Bi‐Directional)
 Output Power: Uplink : +20dBm (maximum peak power)
Downlink : +10dBm
 Type of Modulation: CDMA, GSM (Class V), TDMA, GPRS, EDGE, HSPA
 DC Supply Voltage: 7.5 to 24.0V
 Current Draw: 300ma at 12.0 VDC.
 Battery Power: Switch on/off via ignition switch or 12V DC Adapter
 Operating Temperature: ‐30 to 60° C
 Dimensions: 4.88 x 3.9 x .733 in.
 Weight: 21 oz.
 FCC ID: SO4YX230 under rules part 22 and 24.
 IC: 5544A‐YX230
4