Blaupunkt TravelPilot 100 Instructions Manual page 11

Problem
The device has no or only a very
poor GPS reception.
The device does not recognise
my memory card.
Cause
After switch-on, the device re-
quires approx. 1 minute until it
is ready for navigation. During
the initial switch-on, it requires
a longer time and a strong GPS
signal.
The GPS reception is generally
limited inside of buildings.
Heavily metal-evaporated wind-
shields can interfere with the
GPS reception.
Refl ection and separation,
e.g. due to high-rises, tunnels,
mountains or heavy foliage
Heavy snowfall and (thunder)
storms
Transport of the vehicle by car-
sleeper train or ferry
The memory card is not compat-
ible with this device.
The memory card was format-
ted using the wrong fi le system.
Due to continued technical developments, Blaupunkt cannot guar-
antee the correct functioning of memory cards from different man-
ufacturers and different types of cards. Try a memory card from a
different manufacturer or with a different capacity.
Troubleshooting table
Measure
Move to the outside and place
the device on high ground. Your
device is operational again after
no more than 2 to 5 minutes. At
that time, the navigation is also
possible under less than perfect
conditions.
You may attempt to install the
device in a different location in
the vehicle.
Connect an external GPS an-
tenna.
The device must have a clear
path to the sky. Wait until the
GPS reception is available again.
The route guidance is then con-
tinued automatically.
Use compatible memory cards.
(Ch. "Technical data")
Format the memory card with
the fi le system FAT16 or FAT32.
11