ActionTec SBWD50A User Manual page 35

6. After the upgrade file has been saved to your USB flash drive, a message box pops up,
showing instructions for upgrading ScreenBeam Receivers using the USB flash drive.
7. Follow the onscreen instructions to complete the upgrade. If no message box pops up,
follow the instructions from Step 8 to Step 11 to complete the upgrade.
8. Power on your Receiver. Make sure the "Ready To Connect" screen appears on your
TV.
9. Safely remove the USB flash drive from your PC and connect it to the female connector
of the USB cable.
10. The Receiver starts to upgrade firmware automatically. Please DO NOT power off the
Receiver or remove the USB flash drive during the upgrade process.
11. The Receiver reboots to complete the upgrade, and the "Ready To Connect" screen
appears again. Upgrade completes. You may now remove the USB flash drive from the
Receiver.
32