Usb Mode - ActionTec SBWD50A User Manual

5. Select Wireless Mode, and the utility will scan for available ScreenBeam receivers
automatically.
6. Click the receiver you want to configure to open the configuration or firmware upgrade
page. Now, it is ready for configuration and firmware upgrade.

USB Mode

Follow the procedure below to preparing your system:
1. Complete Steps 1, 2 and 3 in the Preparation for Wireless Mode section.
2. Plug a blank USB flash drive (FAT32 formatted) into your device.
3. From the Windows Start menu, find and launch ScreenBeam Configuration Utility.
(Tip: Search for "ScreenBeam")
4. Select USB Mode, and then select the type of receiver you are going to configure or
upgrade. Click the Next button.
22