Assembly; Cabinet Assembly; Mounting The Table To The Cabinet - Delta 31-482 Operating Instructions And Parts Manual

TOOLS REQUIREd
• 12mm wrench
• Phillips head screw driver
Before beginning assembly, clean all rust protected
surfaces with a mild solvent. Do not use paint or lacquer
thinner, gasoline, or mineral spirits; as these will damage
painted surfaces.
NOTE: To ensure the top cabinet surface, where you will
mount the tool, is level and flush, assemble the cabinet
upside down on a flat surface.
1. Referring to Fig. 2, attach the four rubber pads (A) to
the bottoms of the side panels (B) with four each 5/16"
x 5/8" screws, 5/16" flat washers and 5/16" hex nuts.
2. Use four 5/16" x 5/8" hex cap screws, eight 5/16" flat
washers, four 5/16" lock washers, and four 5/16" hex
nuts to attach the side panels (B) to the front panel (C).
Hand tighten only.
3. Attach the rear cabinet panel (D) to the side panels
using four 5/16" x 5/8" hex cap screws, eight 5/16" flat
washers, four 5/16" lock washers, and four 5/16" hex
nuts.
4. Turn cabinet right side up on a level surface and ensure
the top edges of all panels are flush.
5. Install the cabinet shelf (E) to the inside of the cabinet
using two M5x10 pan head screws, two M5 flat
washers and two M5 lock washers.
6. Tighten all hardware.
MOUNTINg ThE TABLE ASSEMBLY TO ThE CABINET
TOOLS REQUIREd
• 12 mm wrench
This step requires two adults. The table
assembly is heavy, be careful when
lifting it onto the stand! Failure to comply may cause
serious injury and/or damage to the sander and/or
property!
1. With the aid of another person, carefully lift the table
assembly onto the cabinet and position it so that the
two holes in the base of the table assembly align with
the holes located on either end of the cabinet. See
Fig. 3.
2. Open the cabinet door and, from inside the cabinet,
feed a 5/16" x 1-1/4" hex cap screw up through both
holes and secure using a 5/16" lock washer and 5/16"
flat washer. See Fig. 5.
3. Tighten hardware using a 12mm socket wrench.

CABINET ASSEMBLY

PARTS
• Rubber Feet (4)
• Side Cabinet Panels (2)
• Front Cabinet Panel with
Door (1)
• Rear Cabinet Panel (1)
• Cabinet Shelf (1))
PARTS hARdwARE NEEdEd
• Table Assembly • 5/16" x 1-1/4" hex cap screws (2)
• 5/16" lock washers (2) 5/16" flat washers (2)
8
hARdwARE NEEdEd
• 5/16" x 5/8" screws (4)
• 5/16" flat washers (20)
• 5/16" hex nuts (12)
• 5/16" x 5/8" hex cap bolts (8)
• 5/16" lock washers (8)
• M5x10 pan head screws (2)
• M5 flat washers (2)
• M5 lock washers (2)
FIg. 2
FIg.3