Assembly - Delta SA350K Instruction Manual

For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
1. Carefully turn the machine upside down. Place it on a clean, firm, supporting surface.
2. Use a flat-head screwdriver or similar device to remove the plug (A) Fig. 1 to gain access to socket-head screw
(not shown).
3. Carefully place the machine on its side (Fig. 2). Attach the spindle adapter (B) Fig. 2 to the motor shaft (A) by
turning the spindle adapter counter-clockwise on the shaft.
NOTE: Motor shaft has a left-hand thread.
4. Place a 7/16" open-end wrench (D) Fig. 3 (not sup plied) on the flats of spindle adapter (B). Insert a 3/16" hex
wrench (E) Fig. 3 (supplied) into the socket-head screw located where the plug (A) Fig. 1 was removed in STEP 2.
5. Hold the hex wrench (E) Fig. 4 to prevent the motor shaft from turning. Turn the wrench (D) coun ter -clock wise to
fasten the spindle adapter on the motor shaft.
6. Install the plug (A) Fig. 1 that was removed in STEP 2.
A
FIG. 3

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
3/16" Hex Wrench (Supplied)
1/2" Socket Wrench (Supplied)
7/16' open-end wrench
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 1/2 hour.
FIG. 1
B
D
A
FIG. 2
E
7
B
D
FIG. 4