Functional Description; Carton Contents - Delta 23-710 Instruction Manual

EXTENSION CORDS
Use proper extension cords. Make
sure your extension cord is in good condition and
is a 3-wire extension cord which has a 3-prong
grounding type plug and matching receptacle which
will accept the machine's plug. When using an
extension cord, be sure to use one heavy enough to
carry the current of the machine. An undersized cord
will cause a drop in line voltage, resulting in loss
of power and overheating. Fig. D-1 or D-2, shows
the correct gauge to use depending on the cord
length. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
FOREWORD
The Delta Industrial Sharpening Center Model 23-710 has a 1/5 HP motor. It also comes with a 5" diameter, 120 grit
aluminum oxide dry wheel, an 8" diameter, 1000-grit wet wheel, a tool rest and base, a sliding tool holder, a water tank,
eye shield and wrenches.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.
1
10
11
14
17
19
18
23
22

FUNCTIONAL DESCRIPTION

CARTON CONTENTS

4
12
13
16
15
5
20
21
6
MINIMUM gAUgE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Rating Volts
0-6 120
0-6 120
0-6 120
0-6 120
6-10 120
6-10 120
6-10 120
6-10 120
10-12 120
10-12 120
10-12 120
10-12 120
12-16 120
12-16 120
12-16 120
2
3
8
9
7
6
Total
Length of
Cord in gauge of Extension
Feet Cord
up to 25 18 AWg
25-50 16 AWg
50-100 16 AWg
100-150 14 AWg
up to 25 18 AWg
25-50 16 AWg
50-100 14 AWg
100-150 12 AWg
up to 25 16 AWg
25-50 16 AWg
50-100 14 AWg
100-150 12 AWg
up to 25 14 AWg
25-50 12 AWg
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. D-1
1. Sharpening Center
2. Water Tank
3. Tool and Chisel Holder
4. Wheel Dressing Stone
5. Tool and Chisel Holder Base
Assembly
6. Tilting Screw and Spring for
Tool and Chisel Holder w/
(2) Flat Washers
7. 6mm Allen wrench
8. 6mm Allen Wrench
9. Wrench
10. Tool Rest for Dry Wheel
11. Flat Washer
12. Lockwasher
13. 5/8" Long Hex Head Screw
14. Eyeshield Clamp Bracket
15. Eyeshield Mounting Rod
16. Eyeshield Lock Knob
17. 3/4" Long Carriage Head Bolt
18. 1/4-20 Hex Nut
19. Eyeshield Frame
20. 1/2" Long, Round Head Screw
(2)
21. Flat Washer (2)
22. #10-24 Hex Nut (2)
23. Eyeshield