Delta 23-710 Instruction Manual page 9

ASSEMBLINg AND ADJUSTINg
TOOL AND CHISEL HOLDER
1. Take the tool and chisel holder base and insert its
mounting post (A) Fig. 11, into hole (B) in the front of
the machine, and tighten screw (C) against groove (E)
of mounting post. Use the provided wrench (D) Fig.
10.
2. Loosen screw (C) Fig. 13, move tool and chisel hold-
er to desired position and tighten screw (C).
3. Place flat washer, spring and another flat washer
onto the tilting screw knob. Thread tilting screw and
spring assembly (H) Fig. 13, into hole in post. NOTE:
End of screw (H) contacts lever (R) and this screw is
used to tilt the tool rest base (J).
4. To level tool and chisel holder base (J) Fig. 13, with
the set grinding wheel (G), loosen screw (F) with sup-
plied wrench, and turn complete base assembly (E)
until tool and chisel holder base (J) is level with wet
grinding wheel (G), and tighten screw (F).
5. To adjust the height of tool and chisel holder base
assembly (E) Fig. 14, loosen screw (S) and turn ad-
just ment knob (T). Tighten screw (S) after height ad-
justment is made.
H
R
E
A
F
9
A
B
E
C
Fig. 11
g
J
C
Fig. 13
S
E
T
Fig. 14