Configuration And Dip Switches; Switch S1-7: Line Build Out - Patton electronics 2113 User Manual

4.2 CONFIGURATION AND DIP SWITCHES

The CopperLink-T™ T1/E1 Extenders are Plug 'n' Play enabled and do
not require any configuration by the user.
Note The user should NOT change any of the dip switches except
for S1-7 (if necessary). If the user changes the position of any of
the dip switches (except for S1-7), it will affect the operation of
the unit. Refer to Appendix B on page 18 for the factory default
dip switch configuration.

Switch S1-7: Line Build Out

Switch S1-7 defines the shape of the waveform on the T1 or E1 line.
Switch 2113/L/EUI
S1-7 OFF (120)
Table 2: S1-7 Default Position
2113/R/EUI
OFF (120)
15
2115/L/EUI 2115/R/EUI
ON (0.0dB) ON (0.0dB)