Audiovox Pursuit PRO9776C Installation Manual page 10

6 White w/ Black Trace Wire: (+) Siren Output
This is the positive siren feed wire. Route this wire through a grommet in the firewall to the siren location.
Connect the White w/ Black Trace wire to the Red wire of the Siren. Secure the Black wire of the Siren to a
known chassis ground or solid clean metal surface.
7 Green w/ Orange Trace Wire: Tachometer Input Signal
This wire will continually monitor the engine's tach rate while the unit is under power of the Remote Start
module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine compart-
ment and connect to the negative side of the ignition coil. This Remote Start unit learns the tach rate of the
vehicle and in most cases will operate properly from one multi coil pack regardless of the number of cylin-
ders. If the vehicle has a single coil unit for each cylinder, it may be necessary to connect this wire to more
than one cylinder for proper tach reference. See Multi Coil Pack Adaptor wiring detail shown later in this
manual for additional information.
NOTE: For Hybrid mode selection, Bank 3 feature selection 5, this connection is not required, the unit will
start the vehicle and run the allotted time based on feature selection and crank duration.
8 White w/ Red Trace Wire: Parking Light Flasher Input
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are working on
has +12 volt switched parking lights, connect this wire to a fused + 12 volt source. (Max. 15 Amps)
NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.
Parking Light Wiring Detail
10
128-8787b
10 of 32