Table of Contents
Advertisement
Quick Links
Remote Alarm with
Selectable Pre-Load Features
Important! The PRO-9744 alarm system is configurated for many different
user preferences. Please read this entire manual to fully understand the
operation of your specific unit's installation.
FEATURES & OPTIONS:
2 Four Button Anti Code Grabbing Programmable Transmitters
6 Channel Code Learning Receiver
Remote Panic All Modes
Protected Valet/Manual Override
8 Function LED- Armed, Disarmed, Arming, Zone 1, Zone 2, Zone 3,
Zone 4, & Valet
Intrusion Alert With Memory
Audible Arm, Disarm, Defective Zone, and Tamper Indication
Instant Alarm Activation
Starter Disable
True Last Door Arming
Defective Zone By-Pass
Hard Wire Switch Sensing
On Command RF Chirp Delete
6 Tone Multi-Tone Siren (Option)
Multiple Vehicle Operation
On Command R.F. Audible Response Delete
R.F. Shock Sensor Delete
SELECTABLE FEATURES:
Active or Passive Arming
Active or Passive Door Locks
Ignition Control Door Lock On/Off
Ignition Control Door Unlock, (Drivers Door or All Doors), On or Off
Independent RF Headlamp Control
20 Second Headlight Illumination Arm Or Disarm, Both Or None
Panic On Lock Button Or On Separate Button
MODEL PRO-9744WOS2
Owners Manual
(Optional Dual-Stage Shock Sensor required)
-1-
Advertisement
Table of Contents
Related Manuals for Audiovox Pursuit PRO-9744WOS2
Summary of Contents for Audiovox Pursuit PRO-9744WOS2
-
Page 1: Owners Manual
Ignition Control Door Lock On/Off Ignition Control Door Unlock, (Drivers Door or All Doors), On or Off Independent RF Headlamp Control 20 Second Headlight Illumination Arm Or Disarm, Both Or None Panic On Lock Button Or On Separate Button MODEL PRO-9744WOS2 Owners Manual... - Page 2 Operation is the same as described above. GARAGE: The (optional) Audiovox garage door interface will control any existing electric garage door from the maximum operating range of your hand held transmitter. With the interface connected to your...
- Page 3 existing electric garage door, program this transmitter button following the program instructions supplied with your AS-9254 kit. When within range of your garage, press and release this button one time to open or close your garage door. LOCK/UNLOCK: The transmitter button with the combined lock and unlock symbol on it will allow the operator to lock all doors and arm the alarm system, as well as unlock and disarm the alarm system.
-
Page 4: Arming The System, Active
ARMING THE SYSTEM, Active: Turn the engine off, exit the vehicle and close all doors, hood, and trunk. Press and release the transmitter button with the lock icon on it. The parking lights will flash once, the Horn or Siren will beep or chirp once, and the dash mounted LED will begin to flash slowly indicating that the system is armed. -
Page 5: Disarming The System
light will also flash during the triggered mode. A trigger mode will continue for 30 seconds, the alarm will reset, and continue to monitor your vehicle. If the thief left a door opened, the triggered mode will continue for six 30 second cycles, after which, the open door (zone) will be isolated and the system will continue to monitor all other zones. -
Page 6: Intrusion Warning Signals
Warning Signals" shown later in this manual. If upon disarm, the Horn or Siren did not beep or chirp two times, refer to the section entitled "Eliminating The Arm/Disarm Beeps or Chirps". INTRUSION WARNING SIGNALS: The system will warn you if an intrusion attempt has been made in your absence. Upon disarm, the Horn or Siren will beep or chirp four times and the parking lights will flash three times, indicating that the security system had been triggered. -
Page 7: Remote Panic Operation
ELIMINATING THE NORMAL ARM/DISARM BEEPS OR CHIRPS: You can selectively eliminate the normal arm and disarm beeps or chirps by holding the lock or unlock button slightly longer when arming and disarming. This will prevent the Horn or Siren beeps or chirps for one arm or disarm cycle. If you wish to disable these beeps or chirps all the time: Start with the valet/override switch in the off position. -
Page 8: Option Button
STANDARD TRANSMITTER OPTIONS: REMOTE TRUNK RELEASE BUTTON: The remote trunk release option, if installed in your vehicle can be programmed to operate either with a single push of the transmitter button for 2 seconds, or a double push of the transmitter button. The programming of your system is indicated on the card packaged with your transmitter.