Optional Device Channels - Prestige Platinum APS-510C Owner's Manual

1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmit-
ter again for 3 seconds. If the button is not pressed, the alarm will automati-
cally stop after 30 seconds. Also if any transmitter button other than the ARM
or DISARM button is pressed and released, the Panic mode will be turned off
immediately. The normal function of this transmitter button will be sus-
pended during the Panic sounding period.
3. During the panic mode, the Lock and Unlock buttons can be used to lock and
unlock the doors, (if the option is installed), however once the unlock/disarm
button is pressed, the vehicle's starter inhibit device, (where installed) will
be disabled allowing the vehicle to start.
NOTE: While in the Panic mode, pressing and releasing the ARM or DISARM
buttons will, if the option is installed, lock and unlock the doors respec-
tively. While in the panic mode, anytime the DISARM button is pressed,
the panic feature will continue for the allotted 30 seconds, however, the
security system will be disarmed allowing the vehicle to start.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional features that can be connected to a number
of different optional accessories. Some of the more common uses for this channel
are:
 Remote Trunk Release
 Remote Window Closure
Operation of the optional accessory or accessories, can be controlled by
pressing and holding the programmed button on the keychain transmitter for
four seconds, or by pressing and releasing the programmed button on the trans-
mitter two times in succession. Check with your installation center for more
information on what accessories were installed and how they are accessed.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 4 )
This security system has an additional feature that can be connected to a num-
ber of different optional accessories. Some of the more common uses for this
channel are;
 Remote Trunk Release
 Remote Window Closure
To activate the optional accessory, press the programmed button on the key-
chain transmitter for up to 8 seconds for continuous output, or press and release
for momentary activation. The optional accessory will immediately engage. Check
with your installation center for more information on the optional accessory that
may have been installed and how it is accessed.
 Remote Car Starter
 Remote Garage Door Interface
 Remote Car Starter
 Remote Garage Door Interface
Page 11
128-8805b
11 of 16