Disarming The System - Prestige Platinum APS-510C Owner's Manual

seconds, then stop and continue to monitor all protected entry points.
If the thief left a door opened, the alarm will sound for six 30 second
cycles, remain armed and ignore that triggered zone.
 Whenever the system is armed, the dash mounted LED indicator will
slowly flash. This serves as a visual deterrent to the potential thief.
The LED is a very low current bulb and will not cause the vehicle's
battery to drain, even when left unattended for extended periods.
 Whenever the system is triggered, the vehicle's parking lights will
flash for the full 30 second alarm cycle, attracting visual attention to
the vehicle.
 Optional - Whenever the system is armed, the vehicle's starting circuit
will be bypassed. If the thief should choose to ignore the siren, the
vehicle can not be started.
 Any mild impact to the vehicle's glass will cause the alarm to sound a
short series of warning tones.
 Any strong impact to the vehicle's glass will cause the alarm to trigger
for the full 30 second alarm cycle.

DISARMING THE SYSTEM

1. As you approach the vehicle, press and release the Unlock button on the
keychain transmitter.
 Dash mounted LED turns off.
If passive arming was selected during the installation, then the LED
will start flashing rapidly, indicating that the system is rearming auto-
matically. Open any door to suspend the automatic arming.
 Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was trig-
gered in your absence. Before turning the key on, examine the LED to
identify which zone was triggered.
 Siren sounds two chirps.
If the siren sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to iden-
tify which zone was triggered.
If the siren did not sound when disarming, then the chirps have
been turned off, and you should refer to the section titled
"ELIMINATING THE ARM / DISARM CHIRPS" in this manual.
 Doors Unlock - Optional
Note: If the optional 2 step door unlock circuit is installed, when the un-
lock transmitter button is activated, the drivers door only will unlock,
pressing the unlock button a second time will cause all doors to
unlock. If your transmitter has a separate lock unlock buttons, press-
ing the unlock button anytime after the first unlock command will
cause all the vehicle doors to unlock.
Page 5
128-8805b
5 of 16