Grip Warmer Adjusting Knob; Sidestand - Yamaha FJR13AEV(C) Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Grip warmer adjusting knob

This vehicle is equipped with grip
warmers, which can only be used when
the engine is running.
Use the grip warmer adjusting knob, lo-
cated near the accessory box, to adjust
the grip warmer temperature.
3
1. "LO" position
2. "OFF" position
3. " " mark
4. Grip warmer adjusting knob
5. "HI" position
The grip warmer adjusting knob can be
set between the "LO" and "HI" posi-
tions. To raise the temperature, turn the
knob in direction (a). To lower the tem-
perature, turn the knob in direction (b).
Align the " " mark on the knob with
"OFF" to turn the grip warmers off.
EAU40501
NOTE:
When the vehicle is stopped or travel-
ing at extremely low speeds (e.g., in
traffic jams), the grip warmer tempera-
ture is lower than when traveling at
higher speeds.
CAUTION:
G
Be sure to wear gloves when us-
ing the grip warmers.
G
If the ambient temperature is 20
°C (68 °F) or higher, do not set
the grip warmer adjusting knob
to the "HI" position.
G
If the handlebar grip or throttle
grip becomes worn or damaged,
stop using the grip warmers and
replace the grips.
WARNING
Do not turn the grip warmer knob
while the vehicle is moving.
3-26

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
NOTE:
ECA15520
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See further down for an explanation of
the ignition circuit cut-off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
EWA14510
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly as described
EAU15301
EWA10240