Connecting The Front I/O Ports; Usb 2.0 Ports; Esata Port; Ac'97 / Hd Audio Ports - Antec ISK 300-65 User Manual

C
ONNECTING THE
3.1 USB 2.0
Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check
the motherboard manual to ensure that it matches the table below:
1 2
9 10
3.2 SATA
E
You will find a SATA connector on a cable attached to the front ports. This internal SATA
connector is designed to connect to a standard SATA connector on your motherboard. This
will allow high-speed external hard disk enclosures such as the Antec MX-1 to run at the
same speeds as internally installed hard disks.
3.3 AC'97 / HD A
UDIO
There is an Intel® standard 10-pin AC'97 connector and an Intel® 10-pin HDA (High
Definition Audio) connector linked to the front panel of the case.
10 6 4 2
9 7 5 3 1
You can connect either the AC'97 or the HDA connector, depending on your motherboard.
Locate the internal audio connectors from your motherboard or sound card and connect
the corresponding audio cable. Consult your motherboard or sound card manual for the
pin-out positions. Even if your system supports both standards, only use one connector.
F
RONT
Pin Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7
Ground 1
9
Key (No Connection)
P
ORTS
Pin
1
2
3
4
5
6
7
8
9
10
I/O P
ORTS
Pin Signal Names
2 USB Power 2
4 Negative Signal 2
Positive Signal 2
6
Ground 2
8
10 Empty Pin
Signal Names
Pin
(HDA)
MIC2 L 1
AGND 2
MIC2 R 3
AVCC 4
FRO-R 5
MIC2_JD 6
F_IO_SEN 7
Key (no pin) 8
FRO-L 9
LINE2_JD 10
7
Signal Names
(AC'97)
MIC In
GND
MIC Power
NC
Line Out (R)
Line Out (R)
NC
Key (no pin)
Line Out (L)
Line Out (L)