At Antec, we continually refine and improve our products to ensure the highest quality. So it's possible that your new case may differ slightly from the descriptions in this manual. This isn't a problem; it's simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct.
6. Hard Drive LED (labeled HDD) connects to the IDE connector. 7. LED I, LED II connectors: This case comes with two extra LEDs, marked I, II. You may use these LED for various purposes such as SC SI LED, Message LED, etc.
Motherboard Pin Layout for Front Panel IEEE 1394 Connector CONNECTING THE AUDIO PORTS There is an Intel standard 10-pin connector (with 7 individual wires with connectors) coming out from the front panel speaker and microphone connection If your motherboard supports Intel's standard onboard audio connector, you can plug in the 10-pin connector directly onto the board.
These fans must be installed so that the air is blowing into the case. We recommend using Antec 80mm TriCool fans to balance quiet performance with maximum cooling. (See our website for more product information.) Note: Please choose your fan speed wisely.
Page 6
(passive cooling), or with a fan (active cooling) if you are using a high performance VGA card that needs extra cooling. Install the fan so that the air is blowing into the case. We recommend using an Antec 80mm TriCool fan. Maintaining the Washable Air Filter From time to time it will be necessary to wash the installed air filter.