Advertisement
Quick Links
Download this manual
See also:
Manual Del Usuario
Advertisement
Related Manuals for Antec P190
Summary of Contents for Antec P190
- Page 1 P190 User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario...
- Page 2 Disclaimer This manual is intended only as a guide for Antec’s Computer Enclosures. For more comprehensive instructions on installing the motherboard and peripherals, please refer to the user’s manuals that come with those components.
-
Page 3: Cable Management
Note: Please check the motherboard manual for the USB header pin layout and make sure it matches the table below. If it does not match this Intel® standard, please visit Antec’s web store at http://www.antec.com/StoreFront.bok and search for part number 30095 to order a USB Internal Adapter Cable. This adapter... - Page 4 FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE 1394 connector, you will need a FireWire Internal Adapter. To order one, please visit Antec’s web store at http://www.antec.com/StoreFront.bok and search for part number 30031. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector.
-
Page 5: Device Installation
Pin Assignment for Audio Ports (HDA and AC’97) Signal Names Signal Names (HDA) (AC’97) MIC2 L MIC In AGND MIC2 R MIC Power AVCC FRO-R Line Out (R) MIC2_JD Line Out (R) F_IO_SEN Key (no pin) Key (no pin) FRO-L Line Out (L) LINE2_JD Line Out (L) - Page 6 noise-dampening ability of the rubber grommets. Always mount the HDD with the thicker side of the silicone grommets facing up. Repeat the same procedure for other devices as necessary. Connect 4-pin molex or SATA power connectors on the power supply to the power connectors on each of the devices.
- Page 7 or Low to a fan-control device may result in the fan not being able to start. The already lowered voltage from the fan controller will be further reduced by the TriCool™ circuitry below 5V. The Top and Rear Exhaust TriCool™ Fans The case comes with two 140mm top and one 120mm rear exhaust TriCool™...
- Page 8 In order to build a quieter system, we strongly recommend NOT installing the optional fans if you do not require the additional cooling since it will create unnecessary fan noise. If you choose to install them, we recommend using Antec 120mm TriCool™ fans and setting the speed to Low.
- Page 9 To remove the side filter: Open the side panel and disconnect the Molex fan connector from the fan carefully. Slide the filter out For more useful suggestions and advice on building this case please visit Antec’s FAQ’s at www.antec.com.
-
Page 10: Customer Support
1-800-22ANTEC customersupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2007 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China.