Table of Contents
Advertisement
2.4 I
2.5" D
NTERNAL
EVICE
Remove the top panel as described in section 2.1. Included at the top
of the drive tray assembly is a HDD tray that can support up to two
2.5" devices.
1.
On the right side of the drive tray assembly, remove the
thumbscrew holding the HDD tray to the rest of the device.
2.
Slide the HDD tray back a centimeter so the locking hinges
unhook.
3.
Pull the HDD tray away from the drive tray assembly.
4.
Align your 2.5" device with the HDD tray. Invert the tray so the
lower screw holes are accessible, then secure the device to the
tray with the provided Phillips-head screws.
5.
Reattach the HDD tray to the drive tray assembly and replace
the thumbscrew.
6.
Connect the data and power connectors from the motherboard
and power adapter to the device.
2.5 E
S
5.25" D
XTERNAL
LIM
Remove the top panel and drive tray assembly as described in sections 2.1 and 2.2. There is one
externally accessible 5.25" drive bay that is compatible with a slim 5.25" optical drive.
1.
While facing the front of the case, press on the upper right of
the front of the 5.25" drive bay cover until it clicks, then release
to allow the cover to unhinge.
2.
Remove the drive bay face plate by applying pressure to the
inside of the plate until it pops free of the bezel.
3.
Install your slim optical drive in the drive bay assembly by
sliding it into position from the rear of the assembly. Secure the
device in place by attaching the included small screw on the
right-hand side of the tray.
4.
Connect the data and power connectors from the motherboard
and power adapter to the device.
5.
Replace the drive tray assembly in the chassis.
I
NSTALLATION
I
EVICE
NSTALLATION
6
Hide quick links:
Advertisement
Table of Contents
