80mm fan is facing up. Adjust the stands to fi t snugly against the case sides. [Applicable only to models designed for sale in the European Union: All Antec power supplies designed for the EU include a Power Factor Correction (PFC) circuitry in accord with European standard regulation code EN61000-3-2.
Note: Please check your motherboard manual for your USB header pin layout and make sure it matches the attached table. If it does not match this Intel standard, please call Antec customer support at (800) 22ANTEC (North America) or at +31 (0) 10 462-2060 (Europe) to buy a USB adapter.
If you intend to connect the front FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE1394 connector, please call Antec customer ser- vice at (800) 22ANTEC (North America) or +31 (0) 10 462-2060 (Europe) to buy an adapter. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector.
Lift up and slide the drive cage from the case. Place the cage upside down on a fl at surface. Note: You must install the external devices fi rst, before installing the internal 3.5” device. Slide the external 5.25” device into the drive cage from the front. Since the drive cage is upside down, your drive should be too so that it will be properly orientated once the cage is installed in the Minuet II.
Minuet 300 - Explorer Description Description Description Thumbscrews 3.5” Drive Bay Cover Top Panel with Vent Front Bezel Power Supply 5.25” Drive Bay Cover Flip Up Drive Cage Front PCB Assembly Power Switch/Cable Case Power LED/Cable Expansion Slot Covers HD LED/Cable I/O Panel...
Need help?
Do you have a question about the MINUET 300 and is the answer not in the manual?
Questions and answers