Table of Contents
Advertisement
2.4
M
I
OTHERBOARD
NSTALLATION
1. Lay the case down, with the open side facing up.
The drive cages and power supply should be visible.
2. Make sure you have the correct I/O panel for your
motherboard. If the panel provided with the case
isn't suitable, please contact your motherboard
manufacturer for the correct I/O panel.
3. Align your motherboard with the standoff holes and
remember which holes are lined up. Not all
motherboards will match with all the provided
holes; this is normal and won't affect its
functionality.
4. Remove your motherboard by lifting it up.
5. Install standoffs as needed and put the
motherboard back in.
6. Screw in your motherboard to the standoffs with
the provided Phillips‐head screws.
Note: The VSK‐2450 comes with a CPU cutout on the motherboard tray, which will allow you to
change your CPU heatsink without removing the motherboard.
2.5
I
3.5"
D
NTERNAL
EVICE
The VSK‐2450 provides space for up to six 3.5" hard drives. Before you begin, remove the side panels
and front bezel of the case as described in section 2.1. Behind the front bezel there is a fan cage which
provides space for up to two fans at the front of the case.
1.
Open the fan cage by pressing both clips to release
it, then swing it open and detach it from the
chassis.
2.
Insert your 3.5" device into the 3.5" drive cage
from the front of the case until the mounting holes
align with the screw holes in the cage.
3.
Fasten the device in place with the provided
screws.
4.
Mount any other 3.5" HDD devices accordingly.
5.
Connect the appropriate power and data cables to
the device(s).
6.
Replace the fan cage.
I
NSTALLATION
6
Advertisement
Table of Contents
