Glass Replacement; Gasket Replacement - Napoleon EPA 1100 Installation And Operating Instructions Manual

8.6

GLASS REPLACEMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
8.6.1 When the appliance is cool, open the
door and place the door frame down
careful not to scratch the paint.
8.6.2 Remove the screws and brackets
holding the glass in place. Remove
all broken glass.
8.6.3 Wrap the edges of the new glass
with a U-shaped strip of fi berglass
gasket, covering 1/4" on each side.
8.6.4 Place the glass with the fi berglass
gasket in position and replace the
brackets and screws. When fi nished,
you should be able to move the glass
slightly, horizontally and vertically.
NOTE: For replacement glass, size,
thickness and specifi cations see
"REPLACEMENTS" section.
8.7

GASKET REPLACEMENT

At the end of each burning season inspect the shield below the manifold for warping or deterioration. Replace
if necessary. The manifold shield is held to the manifold with machine screws. The replacement shield is
available from your Wolf Steel Ltd. dealer. At this time also check that the door gasket is not worn or loose.
Replace with 3/8" high density fi breglass rope if necessary.
The airwash gasket and shield above the door should also be inspected and replaced if deteriorated.
NOTE: Do not operate appliance if the manifold shield or fi bre baffl e is deteriorated or missing.
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
WARNING
!
56.1
U-SHAPED
GLASS
GASKET
½" ROPE
DOOR
GASKET
W415-0763 / 03.04.10
29