Napoleon EPA 1100 Installation And Operation Instructions Manual

Napoleon EPA 1100 Installation And Operation Instructions Manual

Hi-tech solid fuel burning stoves and inserts

Advertisement

INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.
CERTIFIED UNDER U.S. ENVIRONMENTAL PROTECTION AGENCY (E.P.A.) JULY 1990 AND THE OREGON DEPARTMENT OF ENVIRONMENTAL QUALITY (D.E.Q.) PAR-
TICULATE EMISSION STANDARDS BY E.E.M.C. THESE STOVES HAVE BEEN TESTED AND LISTED BY INTERTEK TESTING SERVICES TO STANDARDS: CSA B366.2 ,
ULCS627, ULC S628, UL 1482. MODEL 1100 HAS BEEN TESTED AND LISTED FOR INSTALLATION IN MOBILE HOMES.
INSTALLATION AND OPERATION INSTRUCTIONS FOR
HI-TECH LISTED SOLID FUEL BURNING STOVES AND INSERTS
FREE STANDING MODELS
INSERT MODELS
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death.
If this unit is not properly installed, a house fire may result.
Follow the installation directions. This unit can be very hot when burning. Combustible mate-
rials such as firewood, wet clothing, etc. placed too close can catch fire. Children and pets
must be kept from touching the unit when it is hot. The chimney must be sound and free of
cracks. Before installing your unit, contact the local building or fire authority and follow their
guidelines.
The door must be kept closed during operation to prevent smoke, embers from entering the
room. Burn wood directly on firebricks. Do not use a grate or elevate the fire. At least 14 square
inches (90 sq.cm.) of outside air must be admitted to the room or directly to the unit through a
4 inch (10cm.) diameter pipe. This unit is designed to burn natural wood only. Higher efficiencies
and lower emissions generally result when burning air dried seasoned hardwoods, as com-
pared to softwoods or to green or freshly cut hardwoods. Do not start a fire with chemicals or
fluids such as gasoline, engine oil, etc. Do not burn treated wood, coal, charcoal, coloured
paper, cardboard, solvents or garbage which tend to produce more pollution than wood. Do
not let the unit become hot enough for any part to glow red.
KEEP THE STOVE TOP TEMPERATURE BELOW 700°F (371°C). Attempts to achieve heat output
rates that exceed design specifications can result in steel distortion and damage.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031
EPA 1100, 1100L, 1100C, 1400, 1400L & 1900
EPI 1101, 1401
WARNING:
FOR YOUR SAFETY
www.napoleonfireplaces.com • ask@napoleon.on.ca
1
W415-0360 / A / 09.04.03

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EPA 1100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Napoleon EPA 1100

  • Page 1 KEEP THE STOVE TOP TEMPERATURE BELOW 700°F (371°C). Attempts to achieve heat output rates that exceed design specifications can result in steel distortion and damage. Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031 www.napoleonfireplaces.com • ask@napoleon.on.ca...
  • Page 2: Table Of Contents

    TABLE of CONTENTS 2-4 INTRODUCTION 10-11 FINISHING Warranty Brick Installation General Information Ornamental Trivet Installation Care of Plated & Enamelled Parts Door and Handles Installation Care of Glass Pedestal Trim Installation 5-6 INSTALLATION Optional Ash Drawer Kit Installing the Legs 11-13 OPERATION Alcove Installation Achieving Proper Draft...
  • Page 3 After the first year, NAPOLEON will not be responsible for installation, labour or any other costs or expenses related to the reinstallation of a warranted part, and such expenses are not covered by this warranty.
  • Page 4: General Information

    5mm thick other appliances in your home competing for air such as: a plate of ceramic glass, available from your Napoleon / Wolf kitchen range hood, forced air heating devices or a bath- Steel Ltd.
  • Page 5 STOVE INSTALLATION INSTALLING THE LEGS STOVE INSTALLATION To avoid being damaged during shipping, the stove has If the stove is to be installed on a been bolted to the pallet and must be unbolted before the combustible floor, it must be placed stove can be installed.
  • Page 6 4 inch upwards a minimum of 1/4" per foot (6mm/ (100mm) diameter fresh air kit available at your Napoleon/Wolf 0.3m) and all connections must be tight and Steel Ltd. dealer. Follow detailed secured by three sheet metal screws equally instructions under "Mobile Home...
  • Page 7: Installation

    LINER EPA certified freestanding stoves and in particular that of 2" DAMPER the EPA 1100 and 1400. External modifications have been FLANGE REMOVED OR made to allow its installation as a "functional fireplace in- sert" with a heat circulating blower system and a means of...
  • Page 8: Installation Into A Factory Built Fireplace

    This guard facilitate hook up into a tight fitting fireplace. Consult your is available from your Napoleon dealer. local dealer for details. The following installation requirements must be observed when installing solid fuel burning inserts into factory built Attach the mounting bracket to the fireplaces.
  • Page 9 1101 BLOWER SERVICE OR REPLACEMENT 1401 BLOWER SERVICE OR REPLACEMENT 1. Turn off all electrical power to the insert. Remove the 1. Turn off all electrical power to the insert. Remove the glass door and set aside in a safe place. GASKET glass door and set aside in a safe place.
  • Page 10 1100/1100C/ 1101 1400/1400L 1401 1900 1100L SIZES 4-#1 4-#1 4-#1 4-#1 4-#7* 1-1/4" x 4"-1/2 x 9" BACK 2-#4 2-#4 2-#4 2-#4 2-#2 1-1/4" x 3" x 9" 1-1/4" x 4-1/2" x 4-1/2" 8-#1 8-#1 12-#1 12-#1 12-#7* SIDES 2-#3 2-#3 2-#3 1-1/4"...
  • Page 11: Ornamental Trivet Installation

    3. Install the bottom bricks, working from the back of the heater while it is in use. unit. Your Napoleon EPA listed product is a Hi-Tech unit, de- 4. Install the 2 bricks along the front. signed with the most advanced technology. The unit is ex- ORNAMENTAL TRIVET INSTALLATION tremely airtight.
  • Page 12: Achieving Proper Draft

    You can now add larger pieces of wood and operate the FIRE EXTINGUISHERS / SMOKE DETECTORS stove normally. Once the stove/insert is entirely hot, it will burn very efficiently with little smoke from the chimney. There All homes with a solid fuel burning fireplace should have at will be a bed of orange coals in the firebox and secondary least one fire extinguisher in a central location known to all, flames flickering just below the top firebrick.
  • Page 13: Smoking

    MAINTENANCE SMOKING A properly installed Napoleon unit should not smoke. If yours Check your chimney and chimney connector for creosote and does, check the following: Has the chimney had time to get soot buildup weekly until a safe frequency for cleaning is estab- hot? Is the smoke passage blocked anywhere in the stove, lished.
  • Page 14: Door Removal

    Ideal lengths of wood are approximately 12" for EPA 1100, 1100C, 1100L and 1101, 16 1/2" for EPA 1400, 1400L and 1401, and 21" for EPA 1900.
  • Page 15: Replacements

    UMBER OF FIREPLACE prices and policies on replacement parts. Normally all parts 2. I NSTALLATION DATE OF FIREPLACE can be ordered through your Napoleon dealer or distributor. 3. P UMBER When ordering replacement parts always give the follow- 4. D...
  • Page 16 W415-0360 / A / 09.04.03...

Table of Contents