Receive; Defeat / Recall Of Factory Presets - Mesa/Boogie TriAxis Owner's Manual

FRONT PANEL:
(Continued)
RECEIVE: (Loading) To load all of your previously written sounds and information into the TriAxis, the procedure is very simple!
4
COPY
FLASHES
PRESET
REAR PANEL
ON/LIFT
OFF
ON GROUND

DEFEAT / RECALL OF FACTORY PRESETS 01 - 20:

RHY
LOOP
SHIFT
SW
LD1
LD2
SW
M B
ESA OOGIE
1 2 3 4
FX LOOP
ALL TUBE PREAMPLIFIER
RHY
SHIFT MODE
LD1
LD2
SW
M B
ESA OOGIE
1 2 3 4
FX LOOP
ALL TUBE PREAMPLIFIER
PROGRAM/CHANNEL
GAIN
IN
MIDI IN JACK
OUTPUT
5
6
4
7
3
2
8
1
9
0
10
A B
OUTPUT
5
6
4
7
3
2 8
1
9
0
10
A B
1. Connect storage medium's Midi Out jack to the TriAxis Midi IN jack.
2. Make sure storage medium is set to transmit the correct information (file)
3. Make sure the PRESETS currently in TriAxis are "Backed Up", as the
load you are preparing to do will erase all existing information in the TriAxis
memory.
4. Key in Transmit or Send on the storage medium. The previously stored info
will be loaded into TriAxis. The PRESET display window will flash four times
confirming that the transmission has been received.
If you run out of Preset Memory using Presets 21 - 90 or you simply prefer
to start writing your sounds at Preset 01, the first 20 factory presets may be
overwritten and yet recalled for future comparison.
1. DEFEAT: Press the SHIFT key once, then the LOOP key. This defeats the
factory preset power load-up command and makes it possible to write mode
and parameter settings of your choice into PRESET locations 01 through 20.
Remember the factory PRESETS will stay in these locations until you
follow this procedure to defeat them.
2. RECALL: To recall the factory PRESETS in their entirety, press the SHIFT
key once, then press the MODE key. Bear in mind this command wipes
out all previously stored information in PRESETS 1 - 20, so be sure you have
BACKED UP your memory if these are important PRESETS in these PRO-
GRAM / LOCATIONS.
PAGE 5