Mesa/Boogie TriAxis Owner's Manual page 27

Table of Contents

Advertisement

CONTROLLER ASSIGN SUB - ROUTINE: (Continued)
STEP 2:
Choose a Parameter. Press any left or right arrowed key under a parameter display and you will see the correspond-
ing display window begin to flash. For now (because you are most likely dealing with a new unit that has never been programmed) all
the parameters are set to Controller 00 (PROGRAM/CHANNEL window).
COPY
00
PRESET
PROGRAM/CHANNEL
Choose a Controller. Press the right arrowed key until the window displays the desired Controller number. Press the
STEP 3:
PROGRAM left arrowed DECREMENT key if you go past the desired controller.
COPY
PRESET
DOWN
NOTE: Remember, the flashing window displays the setting of the parameter NOT the controller number. The Controller number
is displayed only in the "PROGRAM / CHANNEL" window. Don't try to assign the controller to the flashing parameter window by
using the left & right arrowed keys below the parameter window...nothing will happen.
Press the ENTR key one time. The parameter flashing will stop flashing momentarily and the "Controller" number ap-
STEP 4:
pearing in the "PROGRAM WINDOW" will be assigned to this flashing parameter in that preset only.
COPY
ENTR
PRESET
PRESS ONCE ONLY
Repeat. Follow this same procedure for each parameter that you wish to modulate from Step 2 (do not press the SHIFT
STEP 5:
key at this time.) After each parameter/controller assignment, press the ENTR key. Make sure the parameter window stops flash-
ing momentarily, indicating the assignment has been completed. With controllers assigned to all desired parameters, you are now
ready to move to the Value subroutine.
GAIN
TREBLE
PGM
/CH
0
1
2
3
01
PROGRAM/CHANNEL
GAIN
PGM
/CH
0
UP
01
PROGRAM/CHANNEL
GAIN
PGM
/CH
0
FLASH
MIDDLE
BASS
LEAD 1 DRIVE
4
5
6
7
8
PARAMETER KEYS
TREBLE
MIDDLE
1
2
3
4
TREBLE
MIDDLE
1
2
3
4
PAGE 23
LEAD 2 DRIVE
MASTER
9
FLASH
BASS
BASS window display remains
flashing indicating you are
5
assigning a controller to this
parameter.
PAUSE IN
FLASH
BASS
NOTICE THE MOMENTARY
5
PAUSE IN THE FLASHING
PARAMETER WINDOW.
IF YOU ARE NOT SURE
PRESS ENTER AGAIN.
PRESENCE
DYNAMIC VOICE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents