Before Modulation; Pedal Backed Off; Controller Assign; Value Assign - Mesa/Boogie TriAxis Owner's Manual

Mindblowing! Just watching the display windows changing is worth all you coughed up for this baby, isn't it? What did you say ?
you aren't getting anything cool...Let us help.
First...Make sure you read this whole section carefully and thoroughly.
Second...Here is an example of what you can do with the control change software. We'll take Factory Preset 04 and go from the
sparkling clean sound that is the Base Preset and modulate almost everything to produce a low wattage, cranked vintage
amp sound. Follow the 10-step procedure and assign the parameters as follows:

Before Modulation

04
PROGRAM / CHANNEL
PGM
/CH
0

Controller Assign

Assign contoller to 01 in these parameter windows
CONTROLLERS
assigned to
parameters
After Full Modulation
04
PROGRAM / CHANNEL
PGM
/CH
0
The above clean sound (factory preset 04) after modulation
NOTE: If you did presets yet...upon your next power up you may lose your control change assignments.

Pedal Backed Off

5.0 5.0
3.0
GAIN TREBLE MIDDLE
1 2 3 4
01
01
01
01
0.0
0.0
01
01
0.0
Pedal Down
10 7.5
GAIN TREBLE MIDDLE
1 2 3 4
4.5 0.0
BASS LEAD 1 DRIVE
5 6 7 8
GAIN
TREBLE
MIDDLE
BASS
LEAD 1 DRIVE
LEAD 2 DRIVE
MASTER
PRESENCE
DYNAMIC VOICE
1.0 0.0
10
BASS LEAD 1 DRIVE
5 6 7 8
PAGE 26
0.0
5.0
LEAD 2 DRIVE MASTER
9

Value Assign

Assign these Values to the following parameters
08
05
11
105
0.0
0.0
106
109
0.0
0.0
1.0
LEAD 2 DRIVE MASTER
9
Control Change Demo
7.0 0.0
PRESENCE DYNAMIC VOICE
VALUES
assigned to
parameters
2.0 0.0
PRESENCE DYNAMIC VOICE