To Replace Remote Control Receiver - Dimplex EWM-COPPER Parts & Service Manual

If the unit was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.

TO REPLACE REMOTE CONTROL RECEIVER

1. Unplug the unit from the outlet.
2. Remove the two mounting screws from the bottom front of the heater
assembly.
3. Loosen but do not remove the heater / light assembly mounting screws (4)
located on the bottom sides of the wall mounted electric fireplace.
4. Slide the heater and light assembly forward to release it from the bottom
of the wall mounted electric fireplace.
5. Place heater and light assembly on a flat surface and remove the six
screws from the upper sides and back of the assembly.
6. Separate the flicker motor and light assembly from the lower assembly.
7. Locate the remote control receiver board mounted in the lower assembly
cover and disconnect the wiring clips and connections noting their original
locations.
8. Remove receiver board by cutting the 4 plastic mounting posts located on
the 4 corners, flush to the board and then pulling the board off the
remainder of the posts.
9. Push the remaining posts out through the heater assembly cover panel
and insert the replacement posts into the same holes. (Posts are supplied
with replacement board).
10. Properly orient the new board and connect all of the wiring clips and
connections.
11. Reassemble in the reverse order as above.
15