Erasing Tracks; Erasing A Whole Disc; Refreshing A Disc - Tascam CD-RW750 Owner's Manual

5 – After recording

Erasing tracks

It is possible to erase the last recorded track, the last
two recorded tracks, the last three recorded tracks,
etc. It is not, however, possible to erase tracks in the
"middle" of the disc.
1
With the disc loaded, and the unit in stop
mode, press the
ERASE
2
If the display does not show
, where is the number of the last
XX? XX
track recorded on the disc, turn the
control or use the
JOG B
it is displayed.
3
Turn the
MULTI JOG
keys to change the number of the first track to
be erased. The highest value that this number
can take is the last track recorded (e.g. if 17
tracks have been recorded on the disc,
means that the last track only, 17, will be
17
erased). The lowest value that this number can
take is (if this number was
2
would be erased, as described below).

Erasing a whole disc

When you want to erase a whole disc (all the tracks
on a disc), follow the procedure below:
1
With the disc loaded, and the unit in stop
mode, press the
ERASE
2
Turn the
MULTI JOG
keys until the display shows
SKIP I
.
DISC?
3
To erase the contents of the disc, press the
control or press the
MULTI JOG
.
7
NOTE
This operation cannot be undone. If you are going to
erase a disc, make sure that it contains only recordings
that you really want to erase!

Refreshing a disc

If a CD-RW disc has been corrupted at any point (e.g.
power has been cut off in the middle of a finalize
operation, etc.), or has been used in a computer or
another piece of equipment that makes it unreadable,
26
TASCAM CD-RW750 Owner's Manual
key ( or ).
G D
ERASE XX-
MULTI
keys until
SKIP I
control or use the
SKIP
17-
, the whole disc
1
key ( or ).
G D
control or use the
B
ERASE
key
ENTER
NOTE
If only one track has been recorded on the disc, only the
"erase disc" option ("Erasing a whole disc" on page 26)
is available.
4
When the range of tracks to be erased has
been selected, press the
press the key
ENTER
NOTE
This operation cannot be undone. If you are going to
erase a track or tracks, make sure that they are record-
ings that you really want to erase!
5
If you do not want to proceed with the erase
operation, press any other key (such as the
key).
STOP
6
If the erase operation has been selected, the
word flashes on the display, and the
ERASE
timer starts counting down from
seconds).
7
At the end of the countdown period, the word
appears briefly on the display,
Complete
and the display returns to the track/time
display.
4
If you do not want to proceed with the erase
operation, press any other key (such as the
key).
STOP
5
If the erase operation has been selected, the
word flashes on the display, and the
ERASE
timer starts counting down a time value shown
on the display.
6
At the end of the countdown period, the word
appears briefly on the display,
Complete
and the display returns to the track/time
display.
it is possible to "refresh" the disc to make it usable
again. This is equivalent to formatting a disk on a
computer to prepare it for use. This operation
destroys all data on the disc.
control or
MULTI JOG
.
7
(20
0:20