Preparing To Use The Network Twain Scanner - Ricoh Scanner Scanner Manual

Preparing to Use the Network TWAIN Scanner

This section describes the preparations and settings for using the machine as a
network TWAIN scanner.
Important
❒ To use the network TWAIN scanner, an application that supports the scan-
ner, such as DeskTopBinder Lite, must be installed on the computer. Desk-
TopBinder Lite is on the supplied CD-ROM. For details about installing
DeskTopBinder Lite, see "Installing DeskTopBinder Lite from the Supplied
CD-ROM".
A
Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or Wireless LAN
(IEEE 802.11b).
B
Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine's IPv4 address and subnet mask
• In [Effective Protocol], enable [IPv4]
C
Install the TWAIN driver on a client computer.
For details about installing the TWAIN driver, see "Installing the TWAIN
Driver from the Supplied CD-ROM".
Note
❒ To connect the machine to network using a wireless LAN (IEEE 802.11b),
an extended wireless LAN board is required respectively. For details, see
Network Guide.
❒ For details about [System Settings], see General Settings Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For details about the network settings, see General Settings Guide.
Reference
p.104 "Installing the TWAIN Driver from the Supplied CD-ROM"
p.85 "Installing DeskTopBinder Lite from the Supplied CD-ROM"
Before Using the Network TWAIN Scanner
5
103