Freezer Section - Whirlpool KSBS20QEWH0 User Manual

Accessing the Heat Exchanger and Wiring Harness
The heat exchanger, water supply tube to the automatic ice maker and wiring harness are located
under two (2) metal heat exchanger covers on the back of the cabinet.
1. Remove the seven (7) hex-head screws securing the component compartment cover to the
cabinet.
2. Remove the eight (8) hex-head screws securing the long metal cover to the back of the
cabinet.
3. Remove the six (6) hex-head screws securing the L-shaped cover to the back of the cabinet.
The evaporator, automatic ice maker, ice crusher and other associated components are all accessible
inside the freezer section.
Removing the Automatic Ice Maker
1. Remove the extension from the water inlet tube.
2. Remove the hex-head screw securing the bottom
bracket to the back of the freezer section.
3. Loosen the two (2) screws in the slotted brackets at
the top of the automatic ice maker three or four turns.
(These screws must be removed if the rear cover is
to be removed.) (Fig. 14)
4. Slide the automatic ice maker up and off the screws.
5. Disconnect the automatic ice maker wiring harness
connector and remove the automatic ice maker from
the unit.
Servicing the Ice Dispenser Motor
The ice dispenser motor box contains the motor and start capacitor that turns the helix in the ice
container to deliver ice to the "Through The Door" ice dispenser.
Removal:
NOTE: It may be necessary to remove the freezer
compartment light and shelving brackets before the
ice dispenser motor box is to be removed.
(Fig. 15)
1. Remove the four (4) hex-head screws
securing the motor box to the sides
of the freezer compartment.
2. Disconnect the wiring harness con-
nectors from the motor and capacitor
terminals.
3. Carefully slide the motor box straight forward and out of the freezer compartment.

FREEZER SECTION

14
LOOSEN
THESE SCREWS
Fig. 14
THIS SCREW
LOCATOR
TABS
WIRING
HARNESS
PATH
Fig. 15
REMOVE