Whirlpool KSBS20QEWH0 User Manual page 22

Removing Cold Air Damper
1. Remove the control cover.
2. Remove the two (2) phillips-head screws securing
the cold air damper to the duct work. (Fig. 24)
3. Remove the cold air damper from the unit.
ICE AND WATER DISPENSING UNIT
The freezer door contains the drinking water and cubed
and crushed ice dispensing unit. A description of the
cubed and crushed ice delivery process can be found in
Section Two, "Theory of Operation", in this Job Aid.
Drinking water is delivered to the dispenser through a
plastic tube that enters the door through the bottom
hinge. A coupling in the supply tube is located near the
hinge. (Fig. 25) The supply tube travels inside the door
cavity to the right hand lever in the dispenser.
The wiring harness enters the freezer door through
the top hinge. (Fig. 26)
Servicing the Dispenser Assembly
NOTE: Flush Look (Built-In) Models - Remove the two trim-panel channels at the top and bottom of
the front cover before attempting to remove the dispenser assembly.
1. Remove the switch cap and unsnap the two (2) tabs at the bottom of the front cover from the
housing first. Pull the bottom out and lift and the front cover from the housing. (Fig. 27)
2. Remove the two (2) hex-head screws securing the metal control panel cover to the dispenser
housing. This will also free the control bracket from the housing although it will remain tethered
to the freezer door by the wiring harness. (Fig. 28)
3. Disconnect the wiring harness connectors from the terminals
on the switches and light fixture in the control bracket.
Removing the Dispenser Assembly
1. Do the previous three procedures.
2. Remove the eight (8) hex-head screws securing
the dispenser housing to the freezer door. (Fig. 29)
3. Carefully pull the housing from the door.
4. Pull the water supply tube from the top of the dispenser housing.
5. Pull the wiring harness leads from the dispenser housing.
6. Disconnect the wiring harness connectors to the electric
foil heater.
Fig. 24
Fig. 25
18
COLD AIR
DUCT
DAMPER
ASSEMBLY
Fig. 26
Fig. 27