Whirlpool KSBS20QEWH0 User Manual page 8

ALIGNMENT AND LEVELING PROCEDURES FLOW CHART
1. Remove toe grille by
pulling forward at
each end.
2. Turn roller adjust-
ment screw(s) clock-
wise until unit is
firmly on all
roller(s). ( Fig. 6 )
3. If unit is not stable
due to uneven floor-
ing, use shims under
rear roller(s).
1. Remove top hinge
cover. Loosen top
hinge screws. ( Fig. 9 )
2. Adjust both doors so
tops are aligned and
gap is consistent
from top to bottom.
3. Tighten top hinge
screws and replace
the covers.
Slide Unit
into
Final Location.
Is
Unit
NO
Stable?
YES
Are Tops of Doors
Aligned with Each
Other?
(Fig. 7)
YES
Is Center Gap
Consistent from
NO
Top to
Bottom?
( Fig. 8 )
YES
Replace Toe Grille.
4
1. Remove toe grille by
pulling forward at
each end.
2. Turn roller adjust-
ment screw for the
door that is lower
clockwise.
NO
3. Open and close both
doors to confirm
doors are aligned.
4. Repeat until doors
are aligned.
Is
Unit
YES
Stable?
NO
1. Turn roller adjust-
ment screw(s) coun-
terclockwise until
unit is firmly on all
rollers.
2. If unit is not stable
due to uneven floor-
ing, use shims under
rear rollers.