Linksys EFG120 User Manual page 8

From the screen shown in Figure 4-3, once you have found the EFG120 you
wish to set up, highlight and click it. Then, click the Yes button on the right
to change any of the EFG120's settings or the No button to accept the set-
tings and exit the Setup Wizard.
8
Figure 4-3
4. The first settings that you can change are the EFG120's IP Address settings.
As shown in Figure 4-4, select the radio button beside either Fixed IP
Address or Dynamic IP Address.
Figure 4-4
The Fixed IP Address is set by default (192.168.1.77). Use this setting if
there is no DHCP server on your network and you want the EFG120 to use
a static IP Address. With the Fixed IP Address setting, you can also use the
EFG120 as your network's DHCP server. Use the Dynamic IP Address set-
ting if you already have a DHCP server setting IP Addresses on your net-
work devices.
Click the radio button next to your selection. Then, click the Next button on
the right to proceed or the Back button to return to the previous screen.
Proceed to the next step if you are selecting the Fixed IP Address setting. If
selecting Dynamic IP Address, proceed to Step 7.
9