Chapter 4: Using The Efg120'S Setup Wizard - Linksys EFG120 User Manual

Chapter 4: Using the EFG120's
Setup Wizard
Now that everything is connected and powered on, you are ready to configure
the EFG120 so that it is accessible to the users on your network. You will have
to run the EFG120's Setup Wizard on your PC to access the EFG120's Quick
Setup feature. To run the Setup Wizard on your Windows 98, Me, NT 4.0, 2000,
or XP PC, follow the instructions below.
1. Insert the Setup Wizard CD-ROM into your PC's CD-ROM drive.
2. An autorun menu should appear after a few seconds. If the autorun menu
does not appear, click the Start button, select Run, type
D:\SetupUtility.exe (where D is the letter of your CD-ROM drive) into the
Open window and press Enter. The autorun menu appears as shown in
Figure 4-1.
6
Figure 4-1
This Welcome screen provides you with four options buttons along the right
side of the screen. The first button is the Setup button. Click this button to
continue with the setup procedure. The second button is the User Guide
button. The third button, Linksys, connects you to the Linksys web site if
you have an active Internet connection. Lastly, clicking the Exit button will
exit the Setup Wizard.
The remainder of this chapter addresses the setup procedure you would fol-
low by clicking the Setup button.
3. From the following screen, shown in Figure 4-2, the Setup Wizard will
automatically search for any EFG120 currently on your network or attached
to your PC. If it fails to detect the EFG120 or if an EFG120 has been
installed since the Setup Wizard's last search, click Search Again to locate
the EFG120.
Figure 4-2
7