Appendix C: Setting Up The Built-In Printserver - Linksys EFG120 User Manual

11. Plug in the EFG120 and power it back on.
12. Now, access the EFG120's Web-Based Utility, by typing http://
192.168.1.77 in the
PC's web browser
address window, as
shown in Figure B-
6.
13. Click the Administration tab and select Disk. Under Format Disk, Disk 2
will show a status of Not Formatted. Click the Format Disk button for Disk
2 to format that hard drive.
Important: Formatting
a hard drive will delete
all information from
that drive. Always verify
that you do not wish to
save any information on
the drive before format-
ting it.
14. When formatting is complete, the hard drive is ready to use.
40
Figure B-6
Figure B-7
Appendix C: Setting Up the Built-in
PrintServer
Important: As screens vary between operating systems, you may
find that the screenshots in this section look a little different from
your own operating system.
When you're ready to utilize the EFG120's built-in PrintServer, follow these
simple directions:
1. Power down the EFG120 by pressing the button on the front. Then, connect
your printer's parallel cable to the port on the back of the EFG120.
2. Power on the EFG120.
3. When your Windows desktop appears, click the Start button. Select
Settings, and click Control Panel, as shown in Figure C-1.
Important: When
Windows XP, perform these
steps in Classic
Windows and icons appear
different when not in Classic
Mode. For instance, in step 3,
XP users not in Classic Mode
would select Control Panel
after clicking the Start button.
4. From the Control Panel, double click
the Printers folder, shown in Figure
C-2.
using
Mode.
Figure C-1
Figure C-2
41