Standard Seat Depth Adjustment - Quickie Hula Instructions For Use Manual

6.8 Standard Seat Depth Adjustment

1. Remove the 5mm depth adjustment bolts from both
sides of the seat, (Fig.6.11).
2. Slide the rear backrest and armrests into the desired
seat depth position. Reference seat depth position
patterns (A), (Fig.6.12).
3. Replace both sets of depth adjustment bolts.
4. Use 20 Nm or 177lbf/in of torque, (Fig.6.13).
NOTE: Depending on the seat depth, the side guard
position may have to be moved, (see section 5.8.1-
Fig.5.37).
Fig. 6.11
28
HULA
6.9 Backrest Angle Adjustment -4° to +12°
1. Remove the 5mm backrest bracket index bolts (A) on
both sides of the backrest. Loosen the 5mm backrest
bracket pivot bolts (B) on both sides of the backrest.
NOTE: The index bolt (A) may be in a different starting
position than shown below in Fig.6.14.
NOTE: Maximum recline angle on your Quickie Hula is
12 degrees. A feature has been added to the backrest
recline bracket to limit the maximum recline to 12 degrees,
(Fig.6.14.1).
DANGER!
Do not remove the factory fitted recline limitation stud.
Removing the stud could allow an unsafe backrest set up
leading to possible instability of the powerchair which may
in turn lead to injury or death.
Fig. 6.12
2. Tilt the backrest assembly forward or backward to the
desired angle.
NOTE: See angle configurations on next page, (Fig.6.15).
Fig. 6.13
Fig. 6.14
Fig. 6.14.1
Rev.1.0