Monte Carlo Fan Company 5HNR52XXD Series Owner's Manual page 4

19
Attach decorative medallion to blade.
Install the blade with 3 screws in
hardware pack, tighten securely.
Repeat this procedure 4 more times.
22
Align keyslot holes of the light kit
plate and twist to lock. Install the
screw removed in step 21 and tight-
en all 3 screws securely.
For fan with light kit, go to
step 25.
For fan without light kit,
go to step 30
27
Install 3x40 watt candelabra base bulbs.
Bulbs included. WaRNING: over lamp-
ing the fan will result in the fan
lights shutting down till the proper
wattage of bulbs are installed. Reset
the lights by turning off the wall
switch, bracker, or by remote.
Replace bulbs with the correct
wattage bulbs, turn the power on.
20
Attach blade assembly to the motor
and tighten screws securely. Repeat
this process four more times.
23
Loosen 2 screws and remove one
screw from the light kit plate. Keep
the removed screw for later use.
25
Connect white wire from fan to white
wire from light fixture, then connect
the blue wire from fan to the black
wire from light fixture.
28
Attach the glass to the fan.
Install the rubber washer and hex
nut which removed in step 24 to
the thread rod and secure the
glass.
21
Remove 1 screw and loosen the
other 2 screws. Save screw.
24
Remove the finial nut, hex nut, and
rubber washer from the light fitter.
Keep them for later use.
26
Aline keyslot holes of the light fixture
and twist it to lock. Install the screw
removed in step 23 and tighten
securely.
29
Install the decorative finial nut to
the thread rod by screwing to
secure the glass.