www.linksprite.com
Send/response Mode
The data frame whose A is set to '1' uses this transmission mode. The sender needs to wait for
ACK from the receiver after the sender has sent a frame of data. Then it starts to send the next
frame as following:
Continuous sending mode
The data frame whose A is set to '0' uses this transmission mode. The sender can continuously
send frame after it has sent a frame of data. It does not need to wait for the ACK form the
receiver.
4.2.3. Serial Configuration
The following is the configuration of the UART serial port.
Data rate
1 9200/38400/57600/115200 bps
:
Data bit
8 bits
:
Parity bit
n one
:
Stop bit
:
1 bits
34 / 50