www.linksprite.com
1
c lick "Scan" button;
、
2
、
r eturn the scan result;
3.7. TCP Monitor Mode Test
1
A ccurately set the network parameters, and enable TCP monitor mode;
、
2
W LAN module gets in monitor status after a successful connection;
、
3
U se the Internet Explorer in tester 2, and connect to the WLAN module. Fill in IP address
、
and port number with the their actual values;
4
A fter receiving a request, the WLAN module sets up a TCP connection with the Internet
、
Explorer. A message of successful TCP connection and the requested HTTP data sent from the
Internet Explorer are shown in the client software.
25 / 50