Electronics123 DVR8106 Quick Start Manual

Description
This image recording module is a standard module which using 4 bit data for various command control
of the module. In compare to other modules in the same series, this module provides much more
settings for special application
Features
Small in size: 80x55mm
Motion Detect
Capture up to 10 photos per trigger
AVI frame rate and recording duration setting
OSD to show settings in preview screen
DC12V operation
External trigger to capture a photo/AVI
Alarm output when motion detected
Video output to TV
4-bit Keys operation
Preset NTSC or PAL TV system input
Connector Description
Note: the connectors shown below will depend on the firmware design, not applicable for all
models.
Connector
JP1 Select NTSC/PAL
J1 NC
J2 SD card slot
J3 Select AVI/JPG
J4 Keyboard input
J5 Video out
J6 Camera input
J7 Trigger input
J8 Power
J9 Alarm Out
Electrical Characteristics
Parameter
Operation Voltage
Operation Current
Standby Current
Key Definition
Key Name
0001 Snap Shot
0010 OK
0011 Down
0100 NOP
0101 Right
0110 Disp
Note: all other combinations are NOP (no operation)
Function
Need to be selected before power up
For debug purpose,
Support up to 2G SD card
Need to be selected before power up
4 bit binary input with common ground, internal pull
high
2-pins, To output video signal to TV set
4-pins, for video signal in and power supply (option)
Active Low, TG1 for Cam1, TG2 for Cam2
Aux power input, 12V DC, if J6 power no connected
Active low when motion detected
(at room temperature 25C)
Condition
No Video o/p
1
Image Recording Module
With various user setting
Remark
Min Type
7.5 12
238 145
215 130
Key Name
0111 Menu
1000 NOP
1001 Left
1010 UP
1011 Mode
1100 NOP
DVR8106
Max Unit
13.5 V
128 mA
120 mA
rev 1.0